h16tp(x - AJ Maskin AS

CORRECTIVE MAINTEANCE SHEETSheet C039 Folio 1/1CHANGING THE TILT SENSORCaution!Do not use the machineduring maintenanceoperations.1 - Preliminary operations• Put the machine on a flat surface with zero slope.• Put the machine into the maintenance configuration (see correspondingparagraph).• Switch off electric power (see corresponding paragraph).2 - Removing the tilt sensor• Mark and disconnect the electric connections of the tilt sensor.• Remove the tilt sensor (2) by unscrewing the fixing bolts (1).233 - Installing the tilt sensor• Put a new tilt sensor into place and fix using the fixing bolts (1).• Reconnect the electric connections according to the marks made duringdismantling.• Place a spirit level on the top surface of the tilt sensor and set the adjustmentscrews (4) so that the tilt sensor is level.NB:The spirit level (3) is built into certain tilt sensors.• Put the machine back into the operational configuration.HA16/18PX - HA46/51 JRT144 - Tilt sensor operating test• Extend the machine.• Tilt the tilt sensor and check that the buzzer sounds.• Check that after 1 or 2 seconds, extension or travel movements havebeen disabled.2314HA16/18PX nouvelle générationHA46/51JRT New DesignCaution!The buzzer should be audiblefrom the basket.