h16tp(x - AJ Maskin AS

Sheet C079CORRECTIVE MAINTENANCE SHEETCHANGING A FLOW SEPARATORFolio 1/1Caution!Ensure that the oil is not toohot.Caution!Use a container to collect oilto prevent pollution of theenvironment.11 - Preliminary operations• Put the machine in the maintenance configuration (see correspondingparagraph).• Switch off electric power (see corresponding paragraph).2 - Removing a flow separator• Remove the flow separator (1) by unscrewing it.3 - Installing a flow separator• Screw a new flow separator, whose characteristics correspond to themachine in question, into the hydraulic block.• Tighten to the recommended torque:- Flow separator ref. FDC1-10: 47 to 54 Nm. (34 to 39.8 lb.ft)- Flow separator ref. FDC1-16: 108 to 122 Nm (79.6 to 89.9 lb.ft).• Put the machine back into the operational configuration.• Make several movements using the replaced flow separator to purge thecircuit.• Check that the corresponding movement is made correctly.