h16tp(x - AJ Maskin AS

More documents

Recommendations

Info

Repair manual8.6 - OPERATIONS8.6.1 - Summary table.Frequency Ref. OperationEvery day or beforeeach start ofoperationsThe first 50 hours 9123456710Every 50 hours 1112141516171819Every 250 hours 202123Every 500 hours 242526Every 1000 hours 11or every year27Every 2000 hours 282930Every 3000 hoursCheck the following levels• motor oil• hydraulic oil,• diesel.• electric batteries.Check the cleanliness• disel pre-filter, replace it if water or impurities are found.• motor air filter.• machine (in particular, check the tightness of connections and hoses), usethe opportunity to check the condition of the tyres, cables and all accessoriesand equipment.Check the hydrualic oil filter for clogging.Change the cartridge if the clogging indicator is visible.Check the state of wear of the articulation axles.Change the hydraulic oil filter cartridge (see frequency 250 hours).Change the oil of the drive wheel reducers (see frequency 500 hours) (2 points for4x2 model - 4 points for 4x4 model).Check the tightness of the slew ring screws (torque 10 daN.m).Motor: see manufacturer’s manual.Check the level of the drive wheel reducers (see section 5.3.2.2).Grease:• jib articulation axle (for HB44J): 2 points.• basket link part articulation axle: 4 points.• boom base axle: 1 point.• wheel pivot pin axles: 8 points.• steering axle, central pivot pin and clevis pin: 10 points.• slew ring: bearing 2 points.Motor: see manufacturer’s manual.Grease the friction parts of the telescope (spatula). At the same time, check thecondition of the friction pads.Check the tightness of the wheel nuts (torque 32 daN.m).Change the hydraulic filter cartridge.Motor: see manufacturer’s manual.Change the wheel reducer oil. Fill up (capacity 4 x 1.4 litres.for 4*4 and capacity2 x 1.4 litres for 4*2).Ring screws check the tightness and tighten if necessary. (torque 10 daN.m).Motor: see manufacturer’s manual.Empty the hydraulic oil tank.Empty the tank and the whole hydraulic oil circuit.Empty and clean the diesel tank.Grease the rotation reducer: 1 point.Check the condition of the telescope friction pads, the electric cables andhydraulic hoses.REMINDER:The frequencies given above are to be reduced in the case ofwork in difficult conditions (consult the After-Sales departmentif necessary).48
Repair manual8.7 - PRESENCE OF LABELSIt is important to check that the labels and plates warning personnel of thevarious dangers associated with using the machine are in good condition.The labels providing operators with information on machine use andmaintenance must also be checked.An illegible label may lead to incorrect or dangerous use of the machine.Operating instructions:Check the presence of the labels:Check that all the labels described below are legible and in the correctplace. Replace if necessary (spare parts can be supplied on request, ifnecessary).8.7.1 - Label referencesRef Code Qty Description2 3078148220 2 H14TX logo2 3078148210 2 H16TPX logo5 3078146020 2 H14TX floor height + load5 3078149210 2 H16TPX floor height + load7 3078143450 1 Operating instructions8 3078143270 1 Manufacturer’s plate9 3078144130 2 Do not park in the work area10 3078144140 1 Danger of electrocution11 3078143520 1 Hydraulic oil12 3078145070 1 Danger, travel direction13 3078143590 1 Oil level17 3078143640 1 Do not stand on the cover19 3078143600 2 Do not use as an earth20 3078143540a 1 Socket 220V21 3078143680b 1 Read operating manual30 2420505950 1 Warranty activation31 3078145180 1 Do not exchange33 3078144490 4 Sling load capacity for Australia34 3078144510 1 Fuel tank filling for Australia40 2421808660 1 Yellow and black reflective adhesive marking41 3078143570 1 Greasing the slew ring42 3078143530 1 Remove the pin44 3078143630 2 Danger of body crushing47 3078146480 2 Vertical H16TP logo48 3078143930 1 Green arrow49 3078143940 1 Red arrow50 3078148770 1 Haulotte logo52 3078144530 1 Emergency operation for Australia53 3078144520 2 Harness load for Australia54 3078148970 2 Large size Haulotte logo55 3078148410 1 Manual trouble-shooting56 3078144930 1 Basket load conform to standard EN280 for Australia14 3078143620 2 Risk of injury to hand and fingers51 3078148700 1 Acoustic power11 3078148890 1 Biodegradable oil in option49
Page 1: REPAIR MANUALSELF-PROPELLED TELESCO
Page 4 and 5: 21 Repair manual
Page 6 and 7: Repair Manual2.2.1 - H14T(X) size .
Page 8 and 9: Repair Manual5.18.4 - Indicator def
Page 10 and 11: 6Repair Manual
Page 12 and 13: Repair manual1.2 - GENERAL SAFETY I
Page 14 and 15: Repair manual1.3 - RESIDUAL RISKSCa
Page 16 and 17: 1.5 - REPAIRS AND ADJUSTMENTS1.6 -
Page 18 and 19: Repair manualDESCRIPTION H14T(X) Un
Page 20 and 21: Repair manual2.2 - SIZE2.2.1 - H14T
Page 22 and 23: Repair manual2.3 - TIGHTENING TORQU
Page 24 and 25: 20Repair manual
Page 26 and 27: Repair manual3.1.4 - Safety inputsS
Page 30 and 31: Repair manual4.2 - DIAGRAM E 523 -
Page 32 and 33: Repair manual4.4 - DIAGRAM E 523 -
Page 36 and 37: 135 Repair manual5.6 - JIB5.6.1 - U
Page 38 and 39: 135 Repair manual5.10.2 -Platform5.
Page 40 and 41: 135 Repair manual5.18 - OTHER FUNCT
Page 42 and 43: 135 Repair manual6.1.2 - Positions
Page 44 and 45: 135 Repair manual6.1.4 - Positions
Page 46 and 47: Repair manual7.2 - DIAGRAM H16TP(X)
Page 48 and 49: Repair manualTo preserve the integr
Page 50 and 51: Repair manual8.5 - MAINTENANCE PLAN
Page 54 and 55: Repair manualRef Code Qty Descripti
Page 56 and 57: Repair manual8.7.3 - Common "yellow
Page 58 and 59: Repair manual8.7.5 - Labels specifi
Page 60 and 61: Repair manual24 2356
Page 64 and 65: 60135 Repair manual
Page 67 and 68: PREVENTIVE MAINTENANCE SHEETSheet P
Page 69 and 70: PREVENTIVE MAINTENANCE SHEETSheet P
Page 71 and 72: Repair manual10 - OPERATING INCIDEN
Page 73 and 74: Repair manualNo movement available
Page 75 and 76: Repair manual10.1.3 -Travel systemA
Page 77 and 78: Sheet DP015BREAKDOWN DETECTION FLOW
Page 81: Sheet DP016BREAKDOWN DETECTION FLOW
Page 102 and 103:
Sheet DP024BREAKDOWN DETECTION FLOW
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 111 and 112:
Page 113 and 114:
Page 115:
Page 118 and 119:
Page 120 and 121:
Page 123 and 124:
Page 125:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 139:
Page 142 and 143:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Repair manual11 - CORRECTIVE MAINTE
Page 155:
Sheet C010CORRECTIVE MAINTENANCE SH
Page 159 and 160:
Page 161:
Page 165:
CORRECTIVE MAINTENANCE SHEETSheet C
Page 169 and 170:
Page 171:
Page 175:
Page 179:
Page 183:
Page 187 and 188:
Page 189:
Page 193 and 194:
Page 195 and 196:
Page 197:
Page 201 and 202:
Page 203:
Page 207 and 208:
Page 209:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223:
Page 226 and 227:
CORRECTIVE MAINTENANCE SHEETHA16/18
Page 229:
Page 233:
Sheet C083CORRECTIVE MAINTEANCE SHE
Page 236 and 237:
CORRECTIVE MAINTENANCE SHEETFolio 2
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
CORRECTIVE MAINTENANCE SHEET
Page 245:
Page 249 and 250:
Page 251:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Page 272:
show all

h16tp(x - AJ Maskin AS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?