Single-Chip Low Cost Low Power RF-Transceiver (Rev. A)

CC250032.5 Carrier tape and reel specificationCarrier tape and reel is in accordance with EIA Specification 481.Tape and Reel SpecificationPackage Tape Width ComponentPitchHolePitchReelDiameterUnits per ReelQLP 20 12 mm 8 mm 4 mm 13 inches 2500Table 41: Carrier tape and reel specification33 Ordering InformationChipcon PartNumberTI Part Number Description Minimum Order Quantity(MOQ)CC2500-RTY1 CC2500RTK CC2500 QLP20 RoHS Pb-free 490/tray 490 (tray)CC2500-RTR1 CC2500RTKR CC2500 QLP20 RoHS Pb-free 2500/T&R 2500 (tape and reel)CC2500-CC2550DK CC2500-CC2550DK CC2500_CC2550 Development Kit 1CC2500EMK CC2500EMK CC2500 Evaluation Module Kit 1Table 42: Ordering information34 General Information34.1 Document HistoryRevision Date Description/Changes1.2 2006-06-28 Added figures to table on SPI interface timing requirements.Added information about SPI read.Updates to text and included new figure in section on arbitrary length configuration.Updates to section on CRC check. Added information about CRC check whenPKTCTRL0.CC2400_EN=1.Added information on RSSI update rate in section RSSI.Updates to text and included new figures in section on power-on start-up sequence.Changes to wake-on-radio current consumption figures under electrical specifications.Updates to text in section on data FIFO.Added information about how to check for PLL lock in section on VCO.Better explanation of some of the signals in table of GDO signal selection. Also added some moresignals.Added section on wideband modulation not using spread spectrum under section on systemconsiderations and guidelines.Changes to timeout for sync word search in RX in register MCSM2.Changes to wake-on-radio control register WORCTRL. WOR_RES[1:0] settings 10 b and 11 bchanged to Not Applicable (NA).Added more detailed information on PO_TIMEOUT in register MCSM0.Added description of programming bits in registers FOCCFG, BSCFG, AGCCTRL0, FREND1.Changes to ordering information.1.1 2005-10-20 MDMCFG2[7] used. 26-27 MHz crystal range. Chapter 15: description of the 2 optional appendbytes. Added matching information. Added information about using a reference signal instead of acrystal. CRC can only be checked by append bytes or CRC_AUTOFLUSH. Added equation forcalculating RSSI in dBm. Selectivity performance graphs added.1.0 2005-01-24 First preliminary release.Table 43: Document historyPRELIMINARY Data Sheet (Rev.1.2) SWRS040A Page 80 of 83