Untitled - Uhlenbrock

5. MARCo receiver's basic functionsMARCoAfter learning how to program and read an individual LNCV, this chapter will acquaint you withsome basic functions and how to adjust these by configuring LNCVs.5.1 Receiver addressThe module address by which the MARCo-Receiver is identified is in LNCV 0. This is also theaddress for the first detector or double detector.LNCV DescriptionValueRangeFactorydefault0 Module address and track 1 address 1-4095 11Address track 2 (2. single detector) for track 2, or as feedback addressused in Automatic functions 4 - 281-4095 2If the detectors are inserted in two independent locations on the layout and used as a doubledetector, then each detector needs its own address, by which it is identified in the systemlater. While track 1 is identified by the module address (first detector address) in LNCV 0,track 2 is identified by the address in LNCV1. In this case the address in LNCV1 is used as adecoder address.When direction dependent automatic functions are to be employed, the second detector isused for direction recognition. The address in LNCV 1 is used as a feedback address to senda ‘vacant’ or ‘occupied’ message.Method:Call up the LocoNet Programming Menu in the Intellibox as outlined in Chapter 4.5 and enterfollowing steps:Step 1: Call up MARCo-Receiver, as in described Chap. 4.5.Step 2: LNCV 0 Value 2 program Set Module address to 2Step 3: LNCV 1 Value 3 program 2. Detector address (Entry Track 2) is set to value 3.Step 4: End programming5.2 Selection of the different functionsLNCVDescription2 Selection of the different functions of the module:0-1 = Basic function1-3 = switching operation4-28 = automatic functions96-99 = delete functionsValueRange0-10,20-26,96-99Factorydefault2Detailed information to the different functions and how they are adjusted are outlined inchapter 7.23