Untitled - Uhlenbrock

52MARCoLNCV Description60 Station track 5Address (LNCV 0) of the MARCo-Receiver that supervises track 5 of the station61 Route to track 5Instruction for switching the route in Intellibox or IB-Switch, which leads to track 5 of thestation (see also ch. 7.3.5)62-69 Addresses or train categories of the locomotives, which may enter track 570 Station track 6Address (LNCV 0) of the MARCo-Receiver that supervises track 6 of the station71 Route to track 6Instruction for switching the route in Intellibox or IB-Switch, which leads to track 6 of thestation (see also ch. 7.3.5)72-79 Addresses or train categories of the locomotives, which may enter track 680 Station track 7Address (LNCV 0) of the MARCo-Receiver that supervises track 7 of the station81 Route to track 7Instruction for switching the route in Intellibox or IB-Switch, which leads to track 7 of thestation (see also ch. 7.3.5)82-89 Addresses or train categories of the locomotives which may enter track 790 Station track 8Address (LNCV 0) of the MARCo-Receiver that supervises track 8 of the station91 Route to track 8Instruction for switching the route in Intellibox or IB-Switch, which leads to track 8 of thestation (see also ch. 7.3.5)92-99 Addresses or train categories of the locomotives, which may enter track 8100 Station track 9Address (LNCV 0) of the MARCo-Receiver that supervises track 9 of the station101 Route to track 9Instruction for switching the route in Intellibox or IB-Switch, which leads to track 9 of thestation (see also ch. 7.3.5)102-109 Addresses or train categories of the locomotives, which may enter track 9110 Station track 10Address (LNCV 0) of the MARCo-Receiver that supervises track 10 of the station111 Route to track 10Instruction for switching the route in Intellibox or IB-Switch, which leads to track 10 of thestation (see also ch. 7.3.5)112-119 Addresses or train categories of the locomotives, which may enter track 10NOTE• If a locomotive (train) passes over the detectors of the entry manager, it firstly checkswhether the recognized address was programmed for one of the station tracks. If this trackis vacant, the appropriate route is switched. The last instruction of the route switches theentry signal to green and the train heads into its destination track.• If the destination track is occupied, the locomotive waits at the red entry signal, until thedestination track becomes vacant.• A locomotive address can also be programmed for several tracks. Then the locomotive issent to the first vacant track which is found.• If the address of the locomotive is not allocated for any track, the entry manager checks ifthe recognized category is assigned to one of the tracks. If this is the case, it again checksif the track is vacant. If a vacant track is found, the route is switched for entry to this track.The last instruction of the route must switch the entry signal to the station to green. Thetrain enters the station.• Categories can also be assigned to several tracks of the station.• If the entry manager does not find a track for a recognized address or category, it checks ifone of the tracks is approved for the entry by all vehicles (address entry 20000). If a track isprogrammed that way and vacant, the train is moved to there.• The search for a vacant track starts with LNCV 20 of MARCo receiver. Then, all followingLNCV entries are cyclically scanned in ascending order.