Untitled - Uhlenbrock

MARCoTo set a MARCo-Receiver as entry manager to a station the LNCVs are programmed asfollows:LNCV Description Value0 Module and first detector address 1-40952 Automatic mode: entry manager 83 Direction, in which the sequence in LNCV 2 is to be activatedActive when travelling from detector 1 to detector 2Active when travelling from detector 2 to detector 1015 Waiting period for processing solenoids - route or feedback instructions. (in 0-255seconds.)6 Exit signal of the controlled blockS10The exit signal S10 is monitored by the MARCo-Receiver for its state, redsignal stops the train, with green signal the train travels through.Note: The signal does not physically have to be on the layout.10 Block option: The block status is changed from "occupied" to "vacant", if atrain in the block departs or drives through the block’s exit signal (LNCV 6)switches to "red".0The administration of the station is done with LNCVs 20 to 119. Each track uses 10 LNCVsfor the following purpose:• The address of the MARCo-Receiver for the monitoring of the station track• The instruction for switching a route is setup in the Intellibox or IB-Switch. This route mustcontain switching of all turnouts required to free the path to the desired track. The finalinstruction of the route must always switch the station entry signal to green.• The addresses of the locomotives, which may enter a particular track. This can be anindividual Locomotive address, a train category or the Universal address for all locomotives.Up to 8 different entries are possible.LNCV Description20 Station track 1Address (LNCV 0) of the MARCo-Receiver that supervises track 1 of the station21 Route to track 1Instruction for switching the route in Intellibox or IB-Switch, which leads to track 1 of thestation (see also ch. 7.3.5)22 1. Address or train category of the locomotive, which may enter track 123 2. Address or train category of the locomotive, which may enter track 124 3. Address or train category of the locomotive, which may enter track 125 4. Address or train category of the locomotive, which may enter track 126 5. Address or train category of the locomotive, which may enter track 127 6. Address or train category of the locomotive, which may enter track 128 7. Address or train category of the locomotive, which may enter track 129 8. Address or train category of the locomotive, which may enter track 130 Station track 2Address (LNCV 0) of the MARCo-Receiver that supervises track 2 of the station31 Route to track 2Instruction for switching the route in Intellibox or IB-Switch, which leads to track 2 of thestation (see also ch. 7.3.5)32-39 Addresses or train categories of the locomotives, which may enter track 240 Station track 3Address (LNCV 0) of the MARCo-Receiver that supervises track 3 of the station41 Route to track 3Instruction for switching the route in Intellibox or IB-Switch, which leads to track 3 of thestation (see also ch. 7.3.5)42-49 Addresses or train categories of the locomotives, which may enter track 350 Station track 4Address (LNCV 0) of the MARCo-Receiver that supervises track 4 of the station51 Route to track 4Instruction for switching the route in Intellibox or IB-Switch, which leads to track 4 of thestation (see also ch. 7.3.5)52-59 Addresses or train categories of the locomotives, which may enter track 451