Untitled - Uhlenbrock

7.6 Module SettingsWith the help of LNCV 15 various module settings can be affected.MARCoOpt No. Description Selection Value Sum1 Send transfer format (ÜF) to the LocoNet 0Send ÜF Uhlenbrock format with loco address and category 1Send ÜF Digitrax format with loco address and block vacant 2Send ÜF Digitrax format with loco address and block occupied 33 Does not save operating status when switching off 0Saves operating status when switching off 84 Sends no feedback (vacant/occupied) for the block(vacant/occupied)0Sends feedback (vacant/occupied) for the Block16(vacant/occupied) the address in LNCV 1 (address tracl 2) inoperating mode LNCV 2 = 4-12 and 20-285 Sends no feedback (vacant/occupied) for the block(vacant/occupied) for track10Sends feedback (vacant/occupied) for the Block32(vacant/occupied) with the address in LNCV0 (1. Moduleaddress) for track1 in operating mode LNCV 2 = 1 and LNCV 2= 36 Sends no feedback (vacant/occupied) for the block(vacant/occupied) for track20Sends feedback (vacant/occupied) for the Block64(vacant/occupied) with the address in LNCV0 (2. Addresstrack2) for track1 in operating mode LNCV 2 = 1 and LNCV 2 =3Calculated value for LNCV 15With option 1 you can specify whether and which LocoNet protocol format is sent to otherLocoNet devices that will use the MARCo receiver’s reported data (address, category, drivingdirection, receiver address of the MARCo receiver). e.g. if a LocoNet display (item No. 63450)is to Indicate the locomotive address to be used, the MARCo-Receiver must be set to sendUhlenbrock format.With the option 3 you can specify whether the MARCo-Receiver saves status informationwhen the power is switched off.Option number 4 determines if the MARCo-Receiver sends Feedback occupied or vacant withthe address of the second track section (LNCV 1). Only for automatic functions (LNCV 2 = 4 -28).Option number 5 can determine if the MARCo-Receiver sends feedback occupied or vacantwith the module address for track1 (LNCV 0). Only for operating modes Basic function andSwitching function with double detector. (LNCV 2 = 1 or 3)Option number 6 can determine if the MARCo-Receiver sends feedback occupied or vacantwith the address of the second track section (LNCV 1). Only for operating modes Basicfunction and Switching function with double detector. (LNCV 2 = 1 or 3)LNCV 15 is set to 8 in the Factory.Number of valid received Address bytesBefore the locomotive address is sent over the LocoNet and an automatic function isexecuted, a minimum number of vaslid bytes, specified in LNCV 17, must be received by theRailCom Telegrams when a locomotive enters a particular decoder section.LNCV Description Value17 Number of valid received Address bytes that must be received by RailCom 0-255before the address is accepted.73