Untitled - Uhlenbrock

2.3 First test driveMARCoEach freshly inserted MARCo transmitter has a digital address just like a locomotive. Thepreset address is 3. As the locomotive and the MARCo transmitter must have the sameaddress, place the locomotive on the programming track of the Intellibox and program thelocomotive address with a DCC Programming (DCC byte or register programming).The MARCo-Receiver has the factory set module address of 1 and has two switchingfunctions programs. For each recognized locomotive it switches the front light ON whenrunning in one direction and OFF when running in the other direction. When driving thelocomotive or wagon past the detectors, the control LED of the MARCo-Receiver should lightup briefly.Call up the just programmed locomotive address on the controller and drive the locomotiveinto the first track section: the control LED of the MARCo-Receiver should light up briefly.When driving into the track section, the locomotive’s front light should change state. Itswitches ON when driving from section 1 to section 2 and/or OFF when driving from section 2to section 1. If testing with a wagon (without front lighting), observe the state of the indicatorLED of the "function" key on the Intellibox. It changes when driving into the section.If nothing happens, examine the individual steps of the instructions again:• Did the MARCo-Receiver control LED blink as it was being connected to the LocoNet?• Are the four connections and the LocoNet correctly connected?• Did the control LED blink when the vehicle entered the section?9