Untitled - Uhlenbrock

Feedback from when passing a Track SectionMARCoOnly for MARCo-Receiver Automatic functions 4-28In the example a section of track is to be fitted with a double detector and report it as occupiedor vacant when a train enters from track 1 to track 2 or departs.The feedback message for the track section should be via feedback address 10. The MARCo-Receiver has module address 2 and works as a block section with block status reporting. Itsexit signal has address 1.Basic programming of the LNCVs 0-19LNCV Value Type LNCV Value Type0 1 1. Address (module address) 8 0 2. Solenoid/feedback address1 10 2. Address (track 2) 9 0 Speed before stopping2 23 Function (mode) 10 0 Block option3 0 Driving direction 11 0 Solenoid address for on/off Op.4 0 Holding time 12 0 Category option5 0 Delay for solenoid switching 13 0 Address entry manager6 0 Signal to sets 15 17 Module configuration7 0 1. Solenoid/feedback address 19 1 Startup timeSince the 2. Sensor address (LNCV 1) is not used as Sensor address it now works as afeedback address. Thus the entries in LNCVs 80 - 109 from the previous example are nolonger required. The state of the automatic function for block status message (here LNCV 2 =23) is programmed. Also options 1 and 4 must be programmed in the module configurtion(LNCV 15 = 17). If additional operating states are to be saved at power down they are addedto the module configuration (LNCV 15 = 17 + 8 = 25).92