Untitled - Uhlenbrock

MARCoProgram the following LNCVs as indicated in the table:LNCV Description Value2 Set function for shuttle train terminal, with timed departure 44 Waiting time at terminus, 20 seconds 206 Address of exit signal at which the shuttle will wait. In this example the signal that 10is to be switched by the MARCo-Receiver is operated by a solenoid decoder withaddress 1010 Block option: only after 5 seconds after the train has left on a green signal, is thetrack regarded as clear by the MARCo receiver. Only then can a new train enterinto the terminus.5Method:Call up the LocoNet Programming Menu in your Intellibox as described in Chapter 4.5 andexecute the following sequence:Step 1: Call up MARCo-Receiver, as in described Chap. 4.5.Step 2: LNCV 2 Value 98 program Flush MARCo-ReceiverStep 3: LNCV 2 Value 4 program Set function “Shuttle train”Step 4: LNCV 4 Value 20 program Set waiting time in secondsStep 5: LNCV 6 Value 10 program Enter signal address 10Step 6: LNCV 10 Value 5 program Delay in seconds after which the block is ready for thenext trainStep 7: End programmingIf the LNCV 10 is changed as follows, then automatically 10 seconds after the Locomotive’sshuttle train drives off, the signal at address 10 will have its solenoid switched to red.LNCV Description Value10 Block option: 10 seconds after the train has left on a green signal, the MARCo-Receiver will regarded the track as clear. Only then can a new train enter into theterminus. Also the signal will be switched to red.266How to calculate the value 266, to program this operation, is described in chapter 8.5.5"Automatic operation - occupancy detection".NOTE: In order a completely automate a shuttle train two receivers are required, one in eachterminus.26