Download Manual (pdf) - Equus

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
Record by DTC Trigger
This function automatically records (captures) Live Data information
when a DTC sets and saves it in the Scan Tool’s memory. The recorded
(captured) data can be a valuable troubleshooting aid, particularly if you
are experiencing a fault that is causing a DTC to set.
1. While linked to the vehicle, start the
engine, then press and release the
LD/M button.
� The “Test Modes” menu displays.
2. Use the UP and DOWN buttons,
as necessary, to highlight Live Data
Menu, then press the ENTER
button.
� The “Live Data” menu displays.
3. Use the UP and DOWN buttons,
as necessary, to highlight Record Live
Data, then press the ENTER button.
� The "Record Live Data Menu" displays.
4. Use the UP and DOWN buttons,
as necessary, to highlight Record by
DTC trigger, then press the ENTER
button.
� If DTCs are presently stored in the
vehicle’s computer, an advisory
message displays. Use the UP
and DOWN buttons, as
necessary, to highlight Erase DTCs,
then press the ENTER button to
erase DTCs from the vehicle’s
computer. When the Erase process
is complete, the “Record by DTC
Trigger” screen displays.
5. When the "Record by DTC Trigger" screen displays, select the
desired trigger point as follows:
The Scan Tool is capable of recording approximately 100
frames of Live Data. Record by DTC trigger lets you select the
point in time at which you wish the Scan Tool to begin
recording Live Data. You can set the trigger point to record the
100 frames of data before an event (when the DTC sets), after
the event, or in the middle (50 frames before and 50 frames
after the event.
104 OBD2&1