Download Manual (pdf) - Equus

Additional Tests
SPECIAL TEST MENU
6. Repeat steps 3 through 5 to view test results for additional sensors.
When you have finished viewing the retrieved test data, scroll to the
end of the display to select Exit, then press the ENTER button to
return to the “Special Test Menu” screen.
Non-Continuous Test
The Non-Continuous Test function retrieves and displays test results
for emission-related powertrain components and systems that are not
continuously monitored. The tests available are determined by the
vehicle manufacturer.
The Scan Tool does not perform non-continuous test, but
retrieves results from the most recently performed tests from
the on-board computer’s memory. You may retrieve noncontinuous
test results for only one test at any given time.
1. From the "Special Test Menu", use the
UP and DOWN buttons, as
necessary, to highlight Non-
Continuous Test, then press the
ENTER button.
2. A “One moment please. . .” message
displays while the request is sent to the
vehicle’s on-board computer.
� The “Select Test” screen displays.
The screen shows all tests
applicable to the vehicle under test.
Refer to the vehicle’s service repair
manual for information related to
non-continuous tests.
If non-continuous tests are not
supported by the vehicle under test,
an advisory message shows on the
Scan Tool's display. Press the
LD/M button to return to the
Mode Selection menu.
3. Use the UP and DOWN buttons,
as necessary, to highlight the desired
test, then press the ENTER button.
4. When test results have been retrieved,
data for the selected test will show on
the Scan Tool’s display. The display
shows the following information:
� Test ID number
� Module ID number
� Component ID number
112 OBD2&1