Download Manual (pdf) - Equus

7. When the Tool is in the process of
retrieving codes, a "One moment
please..." message shows on the Tool’s
LCD display.
� If the Tool fails to link to the
vehicle’s computer a “Vehicle is not
responding” message shows on the
Tool’s LCD display. Do the following:
- Verify the ignition is ON.
- Check the cable connections at
the Tool and at the vehicle’s DLC.
- Turn the ignition OFF, wait 10-12
seconds, then turn back ON to
reset the computer.
- Press the ENTER button and
repeat steps 3 and 4 as
necessary.
8. If the Tool was able to link to the vehicle
successfully a "Code retrieval was
successful..." message shows temporarily
on the Tool’s LCD display followed
by any retrieved DTCs.
� The Tool will display a code only if
codes are present in the vehicle's
computer memory. If no codes are
present, a "No DTC' are presently
stored in the vehicle's computer"
message is displayed.
Toyota/Lexus OBD1 Systems
CODE RETRIEVAL PROCEDURE
9. If more than one code was retrieved
press the DTC/FF , as necessary, to
display additional codes one at a time.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information. Use the
and buttons, as necessary, to view the additional
information.
10. Disconnect the Tool from the vehicle and turn the ignition key OFF.
11. To prolong battery life, the Tool automatically shuts "Off" after
approximately three minutes with no button activity. The DTCs
retrieved will remain in the Tool's memory, and may be viewed at
any time. If the Tool’s batteries are removed, or if the Tool is relinked
to a vehicle to retrieve codes, any prior codes in its memory
are automatically cleared.
OBD2&1 95