CONELOG® Implant System Prosthetic Restorations - Camlog

CAST-ON TECHNIQUE
BASE FOR BAR ABUTMENT, CAST-ON
Cast bar version with prefabricated bar base made of high-melting cast-on
alloy and burn-out plastic sleeve (POM) for cast-on technique. A prosthetic
screw for bar abutment (hex) based on the diameter is used to fix the bar
base on the CONELOG ® bar abutment. The plastic sleeve of the bar base
can be shortened occlusally to the height of the prosthetic screw. The overall
height of the base is 13 mm.
WAX-UP
The bar wax-up is created based on the planning on the burn-out plastic
sleeve and bar base directly. The wax thickness over the plastic sleeve
should be at least 0.3 mm. The bar base consists of a non-oxidizing alloy.
Do not cover the fine gold margin of the base with wax. Prefabricated bar
components made of wax/plastic can also be used to fabricate a pre-milled
bar construction.
CAUTION!
Do not cover the fine gold margin of the bar base with wax. This can
lead to a surplus of cast-on alloy on or over the margin on the implant
shoulder support.
Base for bar abutment, cast-on
Setting up the bar bases Shortened bar bases
CONELOG ® IMPLANT SYSTEM
PROSTHETIC RESTORATIONS
Base for CONELOG ® ART. NO. ARTICLE MATERIAL
C2263.4300 bar abutment, cast-on,
Cast-on gold
for Ø 3.3/3.8/4.3/5.0 mm, noble metal weight approx. 0.48 g
alloy/POM
POM:
Polyoxymethylene
115