CONELOG® Implant System Prosthetic Restorations - Camlog

CONELOG ® IMPLANT SYSTEM
PROSTHETIC RESTORATIONS
CONELOG ®
BAR ABUTMENT
INSERTING THE BAR CONSTRUCTION
The CONELOG ® bar abutments are transferred from the working cast to
the CONELOG ® implants and screwed in with the prescribed torques. The
finished bar construction is transferred to the CONELOG ® bar abutments
and fixed with new unused prosthetic screws, using a screwdriver (hex)
with 15 Ncm. The newly created full denture is then inserted and checked
for proper fit.
SOLDERED BAR CONSTRUCTION
BASE FOR BAR ABUTMENT, SOLDERABLE
Soldered bar construction with prefabricated bar bases made of solderable
gold alloy. A prosthetic screw for bar abutment (hex) is used to fix the bar
base on the CONELOG ® bar abutment. The height of the bar base is 5.3 mm.
EXAMPLE:
WORKING CAST WITH BAR LAB ANALOGS/SOLDERING AIDS
FOR BAR ABUTMENT (STAINLESS STEEL).
The bar elements are cut accordingly and in consideration of a joining gap
that is as small as possible fitted between the bar bases. The bar components
are mounted to residue-free burn-out plastic, the prosthetic screws
loosen after curing and the bar lifted off the cast. Bar lab analogs/soldering
aids (stainless steel) are inserted in the bar bases and hand tightened with
screws, hex, for bar abutments (thread M 1.6).
With the bar prepared for soldering, a soldering model is fabricated in the
conventional manner.
118
Setting up the solderable
bar bases
Fixed bar components
Bar bases with fitted prefabricated
bar components made of solderable
gold alloy
Base for CONELOG ® ART. NO. ARTICLE MATERIAL
C2258.4300
bar abutment, solderable,
Solderable
for Ø 3.3/3.8/4.3/5.0 mm
gold alloy
Bar lab analogs/soldering aids with bar
and screws, hex, for bar abutment
NOTE
The instruction manuals of the soldering material manufactures must be
observed!
ART. NO. ARTICLE MATERIAL
J4005.1610
Screw, hex, for bar abutment,
for impression taking open tray and for soldering aid, thread M 1.6,
for Ø 3.3/3.8/4.3/5.0 mm
Stainless steel