IRD-2900 Series Professional Integrated Receiver ... - TBC Integration

4.2.4. Filtering
User Manual
Operation and Management
Filtering is a licensing-required feature that allows the user to define a method
for PID filtering on IRD-2900 ASI and IP output ports.
The following describes the filtering procedures, using both front panel and
web-based management interfaces:
FILTERING THROUGH THE FRONT PANEL
To use filtering mode through the front panel perform the following:
1. Configure ASI and/or IP outputs to filtering mode (see section 4.2.3.2). To
access the After Filtering submenus go to:
Configuration����Stream����Output����ASI Output Source����After Filtering
Configuration����Stream����Output����IP Output Source����After Filtering
2. Access the filtering menu by the following path:
Root����Configuration����Stream����Filtering
Filtering
Filtering
1 General General
2 Service Service
3 PID
1-2-2-4
3. Set the following General sub menu parameters: strategy, mode, Bit-rate
mode and bit-rate. (see section 4.2.4.1). To access the General submenus
go to: Configuration����Stream���� Filtering����General
4. In case that the service filtering strategy is selected, set the required
services (see section 4.2.4.2). To access the Service submenus go to:
Configuration����Stream���� Filtering����Service
5. In case the PID filtering strategy is selected, set the required PIDs (see
section 4.2.4.3). To access the General submenus go to:
Configuration����Stream���� Filtering����PID
Page 4-62 (Rev. 4.6/ SW v1.80/ December 2007)