IRD-2900 Series Professional Integrated Receiver ... - TBC Integration

IRD-2900 Series
Professional Integrated Receiver Decoders
FILTERING THROUGH THE WEB-BASED MANAGEMENT
To use filtering mode through the front panel perform the following:
1. Configure ASI or/and IP outputs to filtering mode. To access the Service
submenus go to:
Stream����General����Output����ASI Output Source����After Filtering
Stream����General����Output����IP Output Source����After Filtering
2. Set the following parameters at the filtering sub menu: strategy, mode, Bit-
rate mode and bit-rate (see section 4.2.4.1). To access the Filtering
submenu go to: Stream����Filtering
Figure 4-18 shows the corresponding Filtering web-management screen.
Figure 4-18: Filtering Parameters web-management screen
3. In case the service filtering strategy is selected, set the services (see section
4.2.4.2). To access the Select Services submenu go to:
Stream����Select Services
4. In case the PID filtering strategy is select, set the PIDs (see section 4.2.4.3).
To access the Select PIDs submenu go to: Stream���� Select PIDs
Scopus Documents (p/n 100793) Page 4-63