ATM Option System Reference - Comtech EF Data

5.3.6 Maximum burst size (MBS) in cells
5.3.7 Remote unit name
Values: T1 connection: 0 - 3622 cells/sec
E1 connection: 0 - 4679 cells/sec
Default: 500
SE/PVC Configuration Parameters
Console SNMP Text-based Config
Maximum burst size
(MBS) in cells
atmpvcMaximumBurst-
Size
[atmpvc#] Maximum-
BurstSize
On the SDM-9230 only, when the Service category parameter is set to RT-VBR
or NRT-VBR:
Set this parameter to the Maximum Burst Size (MBS) in cells. This parameter determines
the amount of time that the connection can maintain the maximum rate of transfer
permitted (the value of the Peak cell rate parameter). Use it to accommodate short bursts
of traffic.
The Maximum burst size (MBS) in cells parameter should be set to the number of cells that
typically occur in a traffic burst. In general, you can set it to the value of the Peak cell rate
parameter, and fine tune if required.
NOTE: The MBS cannot handle a transmission rate that is above the SCR for long
periods of time.
For further information and configuration examples, refer to “Configuring the Cell Rate
Parameters for Variable Bit Rate Service Categories” on page 2-20.
Values: 1-65535
Default: 1000
Console SNMP Text-based Config
Remote unit name atmpvcRemoteUnit [atmpvc#] RemoteUnit
The unit to which data from this PVC should be directed. The unit name is defined on the
remote unit using the SETUP/GLOBAL menu, described in the chapter Global Functions
in the Quick Configuration fascicle of this document series. A unit name must be defined
for each NetPerformer that will be participating in the network.
Values: Maximum 16-character string, determined by remote NetPerformer
setup
Default: none
Memotec Inc. 5-7