ATM Option System Reference - Comtech EF Data

ATM Option
5.3.31 IPX SAP
5.3.32 IPX network number
5.3.33 Filter
Console SNMP Text-based Config
IPX SAP atmpvcIpxSap [atmpvc#] IpxSap
Enables or disables the Service Advertising Protocol (SAP) for IPX frames. IPX SAP
frames are exchanged between routers to indicate the nature and location of services
available on a Novell network. Configure the PVC for IPX SAP routing by setting this
parameter to ENABLE. When the IPX SAP parameter is disabled the NetPerformer cannot
transmit an IPX SAP frame, and discards all IPX SAP frames received.
IPX
Values: DISABLE, ENABLE
Default: DISABLE
Console SNMP Text-based Config
IPX network number atmpvcIpxNetNum [atmpvc#] IpxNetNum
The network number of the IPX node that is connected to the PVC. This number is a 4byte
value in hexadecimal representation. The NetPerformer uses IPX network numbers to
forward frames to their final destination.
When the IPX network number is set to 00000000, the local node is unknown. To allow
the NetPerformer to forward IPX frames to their final destination, an internal IPX network
number must be defined, using the Setup IPX menu.
Values: 00000000 - FFFFFFFF
Default: 00000000
Console SNMP Text-based Config
Filter atmpvcFilter [atmpvc#] Filter
PVC traffic filters can be fine tuned on a port-by-port basis. The Filter parameter lets you
select which filters you would like to apply to this PVC connection.
• Enter ALL to apply all traffic filters that have been defined with the SETUP/FIL-
TER command.
Use DP/FILTER to view the current listing. For details on defining and using traffic
filters, refer to the Quality of Service (QoS) fascicle of this document
series.
• Enter NONE to disable filtering on this PVC connection.
• Enter a specific filter number (from 1 to 32) or a set of filter numbers to select a
subset of the filters that have been defined for this NetPerformer unit.
5-18 Memotec Inc.