ATM Option System Reference - Comtech EF Data

2.8.4 SVC in ATMPPP Mode
SE/SVC/
ATMPPP
example
SVC 3> IP address (def:000.000.000.000) ?
SVC 3> Subnet mask (number of bits) (0-32,def:8) ?
{255.000.000.000}
SVC 3> Frame size (128-8192,def:1500) ?
SVC 3> IP RIP (def:V1) ?
SVC 3> IP RIP TX/RX (def:DUPLEX) ?
SVC 3> OSPF (def:DISABLE) ?
SVC 3> IP multicast active (def:NO) ?
SVC 3> NAT enable (def:NO) ?
SVC 3> IPX connection (def:YES) ?
SVC 3> IPX RIP (def:DISABLE) ?
SVC 3> IPX SAP (def:DISABLE) ?
SVC 3> Filter (def:ALL) ?
Configuration
• Mode, SVC Destination address, Local Address, Type, Call Delay, Call Retry
Delay and Peak cell rate (PCR) are described in “ATMPVCR Mode” on page 6-3
• The other parameters are typical of an RFC1483 logical connection, and are fully
described in the appendix “SE/PVC Configuration Parameters” on page 5-1.
Consult the section “RFC1483 Mode” on page 5-37 under the equivalent parameter
name.
ATMPPP mode provides a data traffic transport method using PPP over ATM AAL5
(RFC-2364).
• Use this mode for LAN traffic and Internet access.
SVCATM1>SE
SETUP
Item (BRIDGE/CALLER ID/CLASS/CUSTOM/FILTER/GLOBAL/HUNT/IP/IPX/MAP/
PHONE/
PORT/PU/PPPOE/PPPUSER/PVC/REDUNDANCY/SCHEDULE/SLOT/SVC/USER/VLAN,
def:SLOT) ? SVC
SVC number (1-300,def:1) ? 2
SVC 2> Mode (def:OFF) ? ATMPPP
SVC 2> SVC Destination address
(def:0000000000000000000000000000000000000000) ?
47009181000000003080191D0100000000000100
SVC 2> Local Address (def:00000000000000) ? 00000000000300
SVC 2> Type (def:DEDICATED) ?
SVC 2> Call Delay (1-255,def:5) ?
SVC 2> Call Retry Delay (1-255,def:10) ?
SVC 2> Service category (def:UBR) ? CBR
SVC 2> Peak cell rate (PCR) (0-3622,def:1000) ?
SVC 2> Payload information rate is 384000 bps
SVC 2> Total information rate is 424000 bps
SVC 2> Remote unit name (def:) ? SVCATM2
SVC 2> LLC encapsulation (def:NO) ?
SVC 2> PPP User (def:NONE) ? 1
SVC 1> Silent (def:SEND REQUEST) ?
SVC 1> LCP timeout (seconds) (1-255,def:3) ?
SVC 1> LCP retries, 255 = forever (0-255,def:255) ?
Memotec Inc. 2-31