ATM Option System Reference - Comtech EF Data

ATM Option
3.1 About the Statistic Commands
Display States
(DS)
Once the unit is powered up, the ATM option installed, and the ATM link, channel, PVCs
and SVCs are configured, you can execute NetPerformer statistics commands from the
console to check the status of ATM operations.
NOTE: All of the commands mentioned in this chapter can be executed by users with
FULL or MONITOR console access.
The ATM statistics commands include the following:
• Display States (DS): Provides current status information concerning a specific
slot, PVC or SVC.
NOTE: These statistics can also be displayed in real time with the DPORT, DPVC and
DSVC commands.
• Display Counters (DC): Shows all counters stored in memory, including the mean
or peak value of the transmitter and receiver rates.
• Display Errors (DE): Displays the values of the error counters for all slots, PVCs
and SVCs.
• Check the current number of reserved and configured data channels and ATM
AAL5 VCs by executing the GLOBAL option of the Display Parameters (DP)
command. Refer to “Tips for Configuring Shared RAM Allocation” on page 2-9.
• View any alarms that were triggered using the Display Alarms (DA) command.
• Enable the capture and display of all traffic through the ATM link, PVC or SVC
with the Setup Capture (SC), Start Capture (STC), and View Capture (VC) commands.
Display Counters
(DC)
Unit ID>
(main prompt)
Display Errors
(DE)
Current status Traffic counters
(tx and rx)
Error counters
Display Parameters
(DP)
SLOT PVC SVC SLOT PVC SVC SLOT PVC SVC
GLOBAL
Parameter
values
Figure 3-1: Display Commands in the CLI Tree for ATM Connections
Display Alarms
(DA)
Alarm log
3-2 Memotec Inc.