ATM Option System Reference - Comtech EF Data

ATM Option
5.3.21 OSPF Area ID
5.3.22 OSPF Transit delay
Identifies the area to which this PVC belongs. This parameter requires a 4-byte value in
dotted decimal representation, with a maximum value of 255 for each byte. All routing
protocol packets originating from the PVC are labelled with this Area ID.
The value of this parameter must be the same as the Area ID of the area to which the
attached network belongs. If you want to define subnetted networks as separate areas, you
can use the IP network number as the Area ID.
NOTE: Area ID 000.000.000.000 indicates that this PVC is included in the OSPF
backbone.
The estimated number of seconds required to transmit a Link State Update packet on this
PVC. Link state advertisements contained in the Link State Update packet will have their
age incremented by this amount before transmission.
When configuring the Transit Delay, take into account the transmission and propagation
delays that occur on this port/PVC. For example, you should increase the value of the
Transit Delay for low-speed serial connections. The default value, 1 second, is appropriate
for a LAN connection.
5.3.23 OSPF Retransmit interval
Console SNMP Text-based Config
OSPF Area ID atmpvcOspfAreaId [atmpvc#] OspfAreaId
Values: 000.000.000.000 - 255.255.255.255
Default: 000.000.000.000
Console SNMP Text-based Config
OSPF Transit delay atmpvcOspfTransitDelay [atmpvc#] OspfTransitDelay
Values: 1 - 360
Default: 1
Console SNMP Text-based Config
OSPF Retransmit interval atmpvcOspfRetransmit-
Int
[atmpvc#] OspfRetransmitInt
The number of seconds that elapse between retransmissions of link state advertisements.
This parameter is used for adjacencies that belong to this PVC, and for retransmissions of
5-14 Memotec Inc.