ATM Option System Reference - Comtech EF Data

5.4.12 TONE ON (ms)
5.4.13 TONE OFF (ms)
SE/PVC Configuration Parameters
NOTE: The human voice can produce frequencies which may be interpreted as tones
and then regenerated at the remote site if Tone Regeneration is always ON (set
to 1). To avoid tone regeneration during a conversation, it is recommended
that this parameter be enabled for a limited amount of time (set to 2 to 255).
Values: 0 - 255 sec
Default: 30 sec
Specifies the duration, in milliseconds, of the multi-frequency tone the NetPerformer uses
to generate a single digit.
Specifies the duration, in milliseconds, of the silence the NetPerformer uses between
multi-frequency tones when generating a dial digit string.
The actual duration of the multi-frequency tone depends to a great extent on the user’s
actions, especially for telephones that sound a tone for as long as a number push-button is
pressed. People typically execute a tone duration of 100 - 750 ms, with silence periods of
300 - 1500 ms. Much shorter periods result from automated dialing: typically 60 - 120 ms
for tones, with 50 - 150 ms of silence between tones.
5.4.14 Pulse make/break ratio
Console SNMP Text-based Config
TONE ON (ms) atmpvcVoiceToneOn-ms [atmpvc#] VoiceToneOnms
Values: 30 - 1000 ms (in increments of 10)
Default: 30 ms
Console SNMP Text-based Config
TONE OFF (ms) atmpvcVoiceToneOff-ms [atmpvc#] VoiceToneOffms
Values: 30 - 1000 ms (in increments of 10)
Default: 30 ms
Console SNMP Text-based Config
Pulse make/break ratio atmpvcVoicePulseMake-
Break-ms
[atmpvc#] VoicePulse-
MakeBreak-ms
Memotec Inc. 5-27