ATM Option System Reference - Comtech EF Data

2.5 Configuring the Digital Link
Configuration
Set up the digital link for an ATM interface with the LINK option of the the SETUP/SLOT
command.
To configure the digital link:
1. At the NetPerformer command line prompt, enter the menu sequence: SE � SLOT
2. Select the Slot number of a slot that contains a T1 or E1 interface card
3. Enter LINK
Unit ID>
(main prompt)
Caution: If you change the configuration of a T1 or E1 interface card
while voice calls are active, the calls will be disrupted.
4. Set the Status parameter to ENABLE
5. Set Clock Recovery to ENABLE
6. Set Digital port clock source to the appropriate value for your application:
• INTERNAL to use the internal reference clock
• 1 to 4 to use the clock received from the network via the digital interface card
installed in that slot number
7. Set the Signaling Mode to NONE
Setup (SE)
Figure 2-3: SETUP/SLOT/LINK Path in the CLI Tree
8. Change the other parameters from their default values, if desired.
Slot (SL)
Memotec Inc. 2-13
Link
NONE