- Page 1 and 2: ATM Option NetPerformer ® System R
- Page 3 and 4: Contents Chapter 1: Product Overvie
- Page 5 and 6: 4. 10 ILMI Channel VCI . . . . . .
- Page 7: 5.8.1 ATM Adaptation Layer . . . .
- Page 11 and 12: Product Overview and higher capacit
- Page 13 and 14: 1.2.2 Error Checking 1.2.3 Cell Tra
- Page 15 and 16: Product Overview • Another diffic
- Page 17 and 18: 1.2.7 ATM Addressing Product Overvi
- Page 19 and 20: NOTE: Service categories can be def
- Page 21 and 22: 1.3 ATM Support on the NetPerformer
- Page 23 and 24: Product Overview 7. Link to another
- Page 25 and 26: Product Overview The NetPerformer p
- Page 27 and 28: Product Overview page 1-21). Howeve
- Page 29 and 30: Product Overview - Congestion is de
- Page 31 and 32: 1.3.5 PPP Over AAL5 Product Overvie
- Page 33 and 34: AAL0 Adaptation Layer Product Overv
- Page 35 and 36: Product Overview On the SDM-9360A,
- Page 37 and 38: SVC Modes Supported Product Overvie
- Page 39 and 40: Configuration 2 Memotec Inc. 2-1
- Page 41 and 42: Configuration When you execute the
- Page 43 and 44: Unit ID> (main prompt) Figure 2-1:
- Page 45 and 46: SE/GLOBAL example: with ATM license
- Page 47 and 48: Configuration Included in this calc
- Page 49 and 50: SE/SLOT example: with data channels
- Page 51 and 52: 2.5 Configuring the Digital Link Co
- Page 53 and 54: 2.6 Configuring the ATM Channel Con
- Page 55 and 56: 2.7 Configuring the ATM PVCs Config
- Page 57 and 58: SE/PVC/ ATMPVCR example: on the SDM
- Page 59 and 60:
2.7.2 PVC in AAL1 Mode SE/PVC/AAL1
- Page 61 and 62:
SE/PVC/ RFC1483 example Configurati
- Page 63 and 64:
2.7.6 PVC in ATM-MULTIPLEX Mode SE/
- Page 65 and 66:
2.8.1 SVC in ATMPVCR Mode SE/SVC/ A
- Page 67 and 68:
SE/SVC/ ATMPVCR example: ANSWER Typ
- Page 69 and 70:
2.8.4 SVC in ATMPPP Mode SE/SVC/ AT
- Page 71 and 72:
2.9 Configuration Examples Configur
- Page 73 and 74:
SE/PVC/#/ ATMPVCR example PVC Confi
- Page 75 and 76:
Monitoring and Statistics 3 Memotec
- Page 77 and 78:
Monitoring and Statistics NOTE: Vie
- Page 79 and 80:
Monitoring and Statistics SVC 1> Nu
- Page 81 and 82:
SVC Status Console SNMP SVC Status
- Page 83 and 84:
DSVC/ATM example Monitoring and Sta
- Page 85 and 86:
3.3 Status of ATM PVCs DC/PVC examp
- Page 87 and 88:
DE/PVC example Monitoring and Stati
- Page 89 and 90:
3.4 Viewing Reserved Channels DP/GL
- Page 91 and 92:
3.5 Status of ATM Channels DC/SLOT
- Page 93 and 94:
SE/SLOT/CHANNEL Configuration Param
- Page 95 and 96:
4.4 Scrambling function 4.5 UNI Ver
- Page 97 and 98:
4.8 ATM Signaling Channel VCI SE/SL
- Page 99 and 100:
SE/PVC Configuration Parameters 5 M
- Page 101 and 102:
SE/PVC Configuration Parameters Val
- Page 103 and 104:
5.3.3 Service category Values: SDM-
- Page 105 and 106:
5.3.6 Maximum burst size (MBS) in c
- Page 107 and 108:
SE/PVC Configuration Parameters NOT
- Page 109 and 110:
5.3.16 IP RIP SE/PVC Configuration
- Page 111 and 112:
5.3.20 OSPF face on both sides of t
- Page 113 and 114:
5.3.24 OSPF Hello interval 5.3.25 O
- Page 115 and 116:
5.3.29 IP multicast protocol 5.3.30
- Page 117 and 118:
5.3.34 Broadcast group SE/PVC Confi
- Page 119 and 120:
5.3.37 Cell Packetization SE/PVC Co
- Page 121 and 122:
SE/PVC Configuration Parameters of
- Page 123 and 124:
SE/PVC Configuration Parameters M-l
- Page 125 and 126:
5.4.12 TONE ON (ms) 5.4.13 TONE OFF
- Page 127 and 128:
5.4.16 Fwd digits SE/PVC Configurat
- Page 129 and 130:
5.5 FRF.8 Mode 5.5.1 Port 5.5.2 DLC
- Page 131 and 132:
SE/PVC Configuration Parameters •
- Page 133 and 134:
5.5.8 Frame relay DE bit 5.5.9 Fram
- Page 135 and 136:
5.6 RFC1483 Mode 5.6.1 BRG connecti
- Page 137 and 138:
5.8.2 Remote PVC number 5.8.3 Class
- Page 139 and 140:
SE/SVC Configuration Parameters 6 M
- Page 141 and 142:
6.3 ATMPVCR Mode 6.3.1 SVC Destinat
- Page 143 and 144:
6.3.7 Call Retry Delay 6.3.8 Peak c
- Page 145 and 146:
Index A AAL service classes 1-4 AAL
- Page 147 and 148:
IP RIP password 5-12 IP RIP TX/RX 5
- Page 149 and 150:
ATM Option 5