ATM Option System Reference - Comtech EF Data
ATM Option System Reference - Comtech EF Data
ATM Option System Reference - Comtech EF Data
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6.3.7 Call Retry Delay<br />
6.3.8 Peak cell rate (PCR)<br />
SE/SVC Configuration Parameters<br />
Console SNMP Text-based Config<br />
Call Retry Delay atmsvcCallRetry [atmsvc#] CallRetry<br />
For DEDICATED type only.<br />
Sets the number of seconds that the NetPerformer will wait before retrying a call to the<br />
destination address after a failed attempt.<br />
NOTE: When both sides of an SVC connection are set to Type=DEDICATED, configure<br />
the Call Delay and Call Retry Delay so as to avoid repetitive call collisions.<br />
Values: 1 - 255<br />
Default: 10<br />
Console SNMP Text-based Config<br />
Peak cell rate (PCR) atmsvcPeakCellRate [atmsvc#] PeakCellRate<br />
Sets the maximum cell rate that can be supported by this <strong>ATM</strong> SVC, in cells per second.<br />
Values: T1 interfaces: 0 - 3622<br />
E1 interfaces: 0 - 4679<br />
Default: 1000<br />
NOTE: The other parameters required for configuration of <strong>ATM</strong>PVCR mode are typical<br />
of a PowerCell PVC (PVCR) connection, and are fully described in the<br />
appendix “SE/PVC Configuration Parameters” on page 5-1. For further information,<br />
consult the section “<strong>ATM</strong>PVCR Mode” on page 5-4 under the equivalent<br />
parameter name.<br />
• All SNMP variables have the prefix atmsvc rather than atmpvc<br />
• All text-based configuration entries are under the [atmsvc#] heading rather than<br />
[atmpvc#].<br />
Memotec Inc. 6-5
Change language