ATM Option System Reference - Comtech EF Data

ATM Option
5.3.17 IP RIP TX/RX
This parameter sets the directionality of the RIP version used on the PVC connection.
Configure the PVC for two-way IP RIP routing by setting this parameter to DUPLEX (the
default value). The NetPerformer can generate IP routing tables, and both receive and
transmit RIP frames on this PVC.
You can also enable IP RIP in a single direction. Select the TX ONLY value to allow the
NetPerformer to transmit RIP frames only. The NetPerformer will discard all RIP frames
received at the PVC. Select RX ONLY to allow the NetPerformer to receive RIP frames
only. In this case, the PVC cannot transmit a RIP frame.
5.3.18 IP RIP authentication type
5.3.19 IP RIP password
Console SNMP Text-based Config
IP RIP TX/RX atmpvcIpRipTxRx [atmpvc#] IpRipTxRx
Values: DUPLEX, TX ONLY, RX ONLY
Default: DUPLEX
Console SNMP Text-based Config
IP RIP authentication
type
For IP RIP Version 2 only.
This parameter enables or disables password authentication for the interface. Select
SIMPLE to have the password included in all RIP frames sent from this PVC. Frames
containing authentication that are received at this PVC will be accepted only if the
password is valid. The password is defined using the IP RIP Password parameter,
described below.
Values: NONE, SIMPLE
Default: NONE
atmpvcIpRipAuthType [atmpvc#] IpRipAuthType
Console SNMP Text-based Config
IP RIP password atmpvcIpRipPassword [atmpvc#] IpRipPassword
For IP RIP Version 2 only.
This parameter defines the password to be used on the interface. The password allows the
authentication procedure to generate and/or verify the authentication field in the RIP
header.
NOTE: The value of the IP RIP Password parameter must be the same for each inter-
5-12 Memotec Inc.