Fravol Smart Series Edgebander Manual & Parts List

ATTENTION:
USER’S MANUAL AND MAINTENANCE
Rev 1-03/07 30
Pic. 21
(pict.21) the operator must exclusively work in the entrance entrance (A) or or exit (B) zone
to prevent him from being squashed or caught up between the roller wheels and
the sliding block of the belt. The danger has been reduced at the entrance and
exit of the panels by fixed shelters.
03.5 MATERIAL OF THE GLUE POT SUBJECT TO WEAR AND TEAR
The glue pot is a much stressed mechanical part because of the hard work conditions. In fact
the work temperature is about 210º C (410º F).
In In pict. 23 you can can see the organs which are more commonly subject to wear and tear.
Check that the panel slowly comes into contact with the glue glue roller. A A conic copier, which has
been adjusted adjusted during testing, has the function to to protect it (Fravol (Fravol tests each machine machine before
delivery). Any eventual adjustments adjustments can be carried out out by opening the the small protection box
(see (see pict.22), turning screw (A) for short short stretches stretches and checking the the result.
You can adjust the quantity of glue to smear on the edge of the panel by by turning turning knob knob (B).
Once Once you have carried carried out all the necessary adjustments, close close the protection protection box
Pic. 22