Fravol Smart Series Edgebander Manual & Parts List

USER’S MANUAL AND MAINTENANCE
Change the panel edge cut by proceeding as follows for both units:
1 Loosen the screw (B);
2 Turn the regulation pin (F).
The plate opposite the pin indicates which direction the pin should be turned to
shave the edge closer or further away from the edge of the panel;
3 Fasten the screw (B) tightly.
A08. 03 PNEUMATIC ADJUSTMENTS
Pic. 5
Reduce or raise the pressure of the pneumatic cylinders of the unit
only if strictly necessary.
Before doing it, check that the operating units slide correctly and that
are clean.
You can see the manometers and the corresponding pressure regulators through the
transparent opening on the protection box. (pict. 6)
Rev 1-03/07 A08-5