Fravol Smart Series Edgebander Manual & Parts List

Vary the regulation by proceeding as follows for each unit:
1 Loosen the lever (E) or (F);
USER’S MANUAL AND MAINTENANCE
2 Turn the regulation pin (G) or (H).
The plate opposite the pin indicates which direction the pin should be turned to
shave the edge closer or further away from the panel edge;
3 Lock the lever (E) or (F).
For the ECO version (S1 and S2) make an angled cut by proceeding as follows for both
units (see Fig. 5):
1 Open the protective booth;
2 Remove the top screws (A);
3 Remove the top screw (B);
4 Turn the cutting unit (C) manually;
5 Position the top screws (A) on the holes (D) and fasten;
6 Position the top screw (B) on the hole (E) and fasten;
Pic. 4
Rev 1-03/07 A08-4