Fravol Smart Series Edgebander Manual & Parts List

USER’S MANUAL AND MAINTENANCE
Defect "B" (pict.13) occurs for the whole lenght of the panel.
With reference to picture 9.
Solution: loosen the 4 screws (E) and lower the radial copier (CR) by turning the
adjustment screw (A).
Defects "A" or "B" "B" (pict.12-13) do not occur for the whole lenght of the panel. panel
Solution: Remove the cutter engines by loosening the screw (V) pict. 9 and
disconnecting the electrical supply (S) (pict.9).
With reference to picture 15.
Loosen the 4 screws (D) and laterally move the radial copier (CR) for short stretches by
turning screw (G).
If defect "A" occurs on the corner of the edge that touches the belt, move the copier
(CR) to the right.
If defect "A" occurs occurs on the corner of the panel that touches the the two contrast wheels,
move the copier (CR) to the the left.
fig. 15
Rev 0-12/05 A21-11