Fravol Smart Series Edgebander Manual & Parts List

A24 IR LAMP UNIT ACCESSORY N° 24
A24. 01 DESCRPITION AND GENERAL INSTRUCTION
USER’S MANUAL AND MAINTENANCE
On request, this device is installed on machines that work in environments with
temperatures below the recommended levels (from 15 5 to 35° C).
This lamp is used for heating the surface of the panel anel during durin the machining
phase in order to make the bonding phase easier. er.
Enable the IR lamp unit by pressing key A on n the control panel (Fig. (Fig 1).
WARNING:
Once switched on, it is strictly forbidden
to touch the IR LAMP L during the work
phase; ; when it is i disabled after the work
cycle, always ways wait 4 – 5 minutes before
handling it if
maintenance is required.
The operator runs the risk of burns and
serious injury.
fig. 1
Rev 0-12/05 A24-1