Fravol Smart Series Edgebander Manual & Parts List

A13 BLOWING UNIT ACCESSORY N. 13
USER’S MANUAL AND MAINTENANCE
A13. 01 DESCRPITION AND GENERAL INSTRUCTION
The unit is made up of two hot air blowers with independent temperature and
position adjustments (one blows on the upper part of the edge, while the other in the
lower part).
Some plastics become opaque in the part worked for the removal of shavings. To
make the edge turn back to its original colour you need to heat it with a jet of hot air.
Press programme (A) on the control panel (pict.1) to activate Blowing unit
A13. 02 ADJUSTMENT
The following adjustments are possible for each blower (pict. 2):
1 Loosen screw (A) to adjust the angle and the horizontal position of the upper
blower blower and and loosen loosen screw screw (B) to adjust that of the lower blower; turn turn the
blower blower manually until it is in the position needed needed and refasten the screws.
You can lift or lower the blowers loosing screw (E or F).
2 A ring nut (C or D) changes the temperature of the air leaving the nozzles
(0°- 600°).
Rev 1-03/07 A13.1
Pic. 1