Fravol Smart Series Edgebander Manual & Parts List

USER’S MANUAL AND MAINTENANCE
Pic. 5
In the event of “excessive xcessive edge roughing” (A) reverse the front copier by carrying out
the following operations (see Fig. 6):
1. open the protective booth;
2. loosen the knobs (A) that lock the copier;
3. loosen the nut (B) on the PVC ABS 2 – 3 mm sector (see label);
4. gradually fasten (clockwise) the dowel (C);
5. tighten the nut (B);
6. place the edge in between and tighten the knobs (A);
7. close the booth;
8. now try to round the edge again. If necessary use the levers (pos. I-K Fig. 3) to
change the position of the radius;
9. change machining type (from ROUNDING to ROUGHING at 0° and/or vice versa),
follow the operations described in paragraph A09.02.01 then check the result of the
roughing on the panel.
If the roughing is still excessive, repeat all the operations o (1 - 9) until a perfect tangent
has been achieved between the edge and the panel.
In the event of “incomplete edge roughing” roughing (B) forward the front copier by following
these instructions (see Fig. 6):
1. open the protective booth;
2. loosen the knobs (A) that lock the copier;
3. loosen the nut (B) on the PVC ABS 2 – 3 mm sector (see label);
4. Loosen the dowel (C) gradually;
5. tighten the nut (B);
6. place the edge in between and tighten the knobs (A);
7. close the booth;
8. now try to round the edge again. If necessary use the levers (pos. I-K Fig. 3) to
change the position of the radius;
9. change machining type (from ROUNDING to ROUGHING at 0° and/or vice
versa), follow the operations described in paragraph A09.02.01 then check the
result of the roughing on the panel.
Rev 1-03/07 A09-6