Technical Manual - Tunstall GmbH

11. Function check
11.1 Checking that the nurse call system is free of
faults
11.1.1 Fault displays on equipment for the nursing staff
74
Faults are shown in the display (”Fault”, ”FLT” or ”FR”) of the following devices,
along with the fault location:
On corridor displays (scrolling) and alternately with calls and presences.
On the terminal SD6 P (when presence is activated) when scrolling through
the current messages or directly when there are no calls and presences.
On the display module (when presence is activated), alternately with calls
and presences.
Here, the faults are displayed in the same way as calls, i.e. initially only in their
own ward or, in the case of group coupling, in the coupled wards. If the fault is
not remedied within the call overflow time, it is displayed in all wards in the build‐
ing.
11.1.1.1 ConLog PLUS Management Software
All of the nurse call system's fault messages can be identified in the
ConLog PLUS management software by looking at and evaluating the call docu‐
mentation of the messages present.
11.1.2 Fault messages on equipment for technicians
11.1.2.1 Group Electronic
Button 1
Button 3
Button 5
Button 2
Button 4
Button 6
Fault on group bus when LED in button 5 is permanently on or off.
Fault on ward bus when LED in button 6 is permanently on or off. The output
to the fault signal lamp also switches.
Group Electronic faulty or is not completely programmed when LED in but‐
ton 2 is on. The fault signal relay (potential-free) also switches.
CONCENTO PLUS - Technical Manual, 11/12 (Rev. 3.0), 00 8814 14