Technical Manual - Tunstall GmbH

Display module, order no. 19 0700 80
Connecting the wires to the connectors and setting the DIP switches
RL
Room lamp 7 )
AW
WL
Ward bus (data)
GND
IA
WH(YE)
R3
IB
YE
R4
00 8814 02, 10/12 (Rev. 4.0) 2
Technical Manual Page 91
+24 V
GND
BU
+24 V
+24V
BN
R1
R2
WR
12 11 10 9 8 7 6 5 4 3 2 1
4
IA
R3 = Call button bed 3 1 ) 3 )
R4 = Door alarm 1 ) 2 ) 3 )
IB
3 2 1
GND
R1 = Call button bed 1 1 ) 3 )
+24 V
Display module is first or last ward
bus user (= bus termination).
WC calls can be cancelled with the
WC cancel button or the presence
button.
R2 = Call button bed 2 1 ) 3 )
WC call button 3 )
WC cancel button 3 )
WA
Legend:
1 ) In CONCENTO PLUS systems the call type and
contact type can be changed, refer to chapter
“Configuration“ on page 3.
2 ) In Concento systems R4 = Room call.
3 ) Maximum 4 monitored devices per input.
4 ) RL colour = YE. For room lamp only = RD.
5 ) WL colour = YE. For room lamp only = WH.
6 ) WA colour = WH. For room lamp only = WH(GN).
7 ) Switching power per output: 100 mA at 24 V DC.
One wire
Oour wires
Output
Input
4-pole connector
Max. wire cross-section: 2.5 mm 2
Power supply (input)
Note! All inputs are pre-programmed as NO contacts.
12-pole connector
ON
OFF
1 2
Display module is neither first nor
last ward bus user.
WC calls can be cancelled only with
the WC cancel button.
3
DIP switches 1, 2, 3
DIP Switch ON OFF
Factory Setting
1
2
3
YE 4 )
YE
YE 5 )
BK or BU
WH
WH
RD
RD
WH
Not all ward bus users are
CONCENTO PLUS type. One or more
ward bus users are Concento type,
order no.:
- Group electronic: 10 0700 10
- Terminals: 10 0700 x0
- Display module: 10 0700 8x
- RAB: 10 0701 x0
WH
WH
WH 6 )
All ward bus users are CONCENTO PLUS
type, order no.:
- Group electronic: 19 0700 10
- Terminals: 19 0700 x0
- Display module: 19 0700 80
- RAB: 19 0701 00
OFF
OFF
OFF
Tunstall GmbH, Orkotten 66, D-48291 Telgte, www.tunstall.de