Operator's Manual – AutoCycle iC - Ferguson Beauregard

Recommendations

Info

ACiC Operator’s Manual Revision 4 Page 32 of 95 TEST LCD: Selecting this option will illuminate all the pixels on the display for troubleshooting. Press MENU/ESC to exit. TEST KDT: Selecting this option will enable a keypad test mode that prints any pressed key (except MENU/ESC) to the display. Press MENU/ESC to exit. 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
ACiC Operator’s Manual Revision 4 Page 33 of 95 4.7.4 F4 – Setup SCROLL LIST SETUP: Scroll List Setup allows you to configure the scroll list with 16 menu items that have Hotkeys. Highlight Scroll List Setup then press the ENTER key to display the first 4 lines for setting up the scroll list. Press the ENTER key to access the data field then enter the Hotkey number of the menu item to be displayed. Press the ENTER key again to accept the value. SCROLL LIST: Scroll List is disables or enables the scroll list without removing the existing hotkeys. If the SCROLL LIST has been turned ON but the SCROLL LIST SETUP has not been configured with at least one HOT KEY menu item, the display will be blank. UNITS: The Units setting will perform a Metric-to-English or English-to-Metric conversion on pressure and temperature readings. Care should be taken to ensure it is set properly prior to calibration. The following options are only applicable if connecting to a third party flow computer for gas measurement. SETUP FCU: Setup FCU is a specific application that allows connections to a TotalFlow FCU. FCU ADDRESS: FCU Address is the modbus slave address that has been assigned to the FCU. MB STATUS: MB Status is used for diagnosing problems when connecting an FCU. The different status indications are listed below: 0000 – the RTU was able to communicate without error. FFFF – the communication attempt to the FCU got no response. FFFE – the response from the device failed CRC16 data integrity check. FFFD – incorrect modbus address in the response FFFC – FCU error code received in response FFFB – byte count error in response. FFFA – the FCU is not setup. FFF9 – the FCU port is busy. FFF8 – no FCU is connected to the RTU. SEND FCU SETUP: Send FCU Setup is the command to activate communication and data retrieval from the FCU. Highlight SEND FCU then press the ENTER key. There will be no visual confirmation. Check MB STATUS for an indication of communication success or failure. 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
Page 1 and 2: Operator’s Manual Revision: 4 Rev
Page 3 and 4: ACiC Operator’s Manual Revision 4
Page 31: ACiC Operator’s Manual Revision 4
Page 73 and 74: 1. 2. 3. 4. 5. 6. 7. 8. 9. ACiC Ope
Page 77 and 78: 1. 2. 3. 4. 5. 6. ACiC Operator’s
Page 83 and 84:
ACiC Operator’s Manual Revision 4
Page 85 and 86:
1. 2. 3. 4. 5. 6. 7. ACiC Operator
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95:
8. 9. ACiC Operator’s Manual Revi
show all

Operator's Manual – AutoCycle iC - Ferguson Beauregard

Create successful ePaper yourself

Delete template?

Save as template?