Operator's Manual – AutoCycle iC - Ferguson Beauregard

Recommendations

Info

ACiC Operator’s Manual Revision 4 Page 76 of 95 7.3.2 ROC 809 Configuration ROC 800 CPU Module CPU ETHERNET Ethernet RS-232 LED LOI Status RESET FISHER ROC 800 RS-232D LNK COL TX RX DTR RTS TX RX GND ROC 800 RS-232 Module RS-232 RX TX RTS CTS COM To ACiC Figure 7.21: ROC 800 Wiring Diagram ROC Terminal ROC Function A30606VM Wire Color PC 232CONV Pin 1 TX Red Pin 2 Pin 2 RX Green Pin 1 Pin 5 GND Black Pin 5 Table 7.15: ROC 800 Wiring Table To ACiC 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
1. 2. 3. 4. 5. 6. ACiC Operator’s Manual Revision 4 Page 77 of 95 Use ROCLINK 800 to connect to the ROC 809. From the ROC menu, select Comm Ports. Choose the Comm port being used from the menu. Set the Baud Rate, Data Bits, Parity, and Stop Bits to 19200, 8, None, and 1. Set the Port Owner to Modbus Slave Only. Click Apply. Click OK. Figure 7.23: ROC Modbus Configuration Figure 7.22: ROC Communications Configuration 7. From the Configure menu, choose Modbus, then Configuration. 8. Choose the Comm port being used from the menu. 9. Set the Byte Order to Most Significant Byte First. 10. Click Apply. Click OK. 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
Page 1 and 2:
Operator’s Manual Revision: 4 Rev
Page 3 and 4:
ACiC Operator’s Manual Revision 4
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26: ACiC Operator’s Manual Revision 4
Page 73 and 74: 1. 2. 3. 4. 5. 6. 7. 8. 9. ACiC Ope
Page 75: ACiC Operator’s Manual Revision 4
Page 85 and 86: 1. 2. 3. 4. 5. 6. 7. ACiC Operator
Page 95: 8. 9. ACiC Operator’s Manual Revi
show all

Operator's Manual – AutoCycle iC - Ferguson Beauregard

Create successful ePaper yourself

Delete template?

Save as template?