Operator's Manual – AutoCycle iC - Ferguson Beauregard

Recommendations

Info

ACiC Operator’s Manual Revision 4 Page 74 of 95 7.3 Emerson Fisher ROC To configure the FloBoss unit you will need the ROCLink 800 or ROCLink for Windows application provided by Emerson Process Management at http://www.emersonprocess.com. Included in the section are examples for configuring the following flow computers: Emerson Fisher ROC 809 Orifice Meter Emerson Fisher ROC 809 Turbine Meter 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
ACiC Operator’s Manual Revision 4 Page 75 of 95 7.3.1 ACiC Configuration for Fisher ROC 1. Open the ACiC in iCConnect and choose the Input Config tab 2. Set the Differential pressure analog channel, Line Pressure analog channel, and Line Temperature analog channel to FCU. 3. Click the Save button. 4. Choose System tab. 5. Set the port setup sections according to Table 7.13. 6. Click the Save button. 7. Choose the FCU tab. 8. Set the appropriate MODBUS address of the ROC 9. Set all the other FCU parameters as according to Table 7.14. 10. Click the Save button. Setting Value Port Setup (Serial or TTL) Baud Rate 19200 Parity None Flow Control No flow control Stop Bits 1 Stop bit Data Bits 8 Data bits Port Device External Device Port Protocol Flow computer (FCU) Table 7.13: iCConnect System Tab - ROC Setting Value Capture window Previous volume capture window end 60 Previous volume capture window start 0 FCU Communications FCU’s MODBUS mode False FCU’s slave mode True Flow computer present True MODBUS address 1 Prefix byte 0 Prefix byte count 0 Suffix byte 0 Suffix byte count 0 FCU Data Format Byte order DCBA Data type Single precision float Flow computer type Fisher ROC Flow rate definition MCF per day Units False FCU Registers Current volume address 7005 DP address 7000 (7001 for Turbine) Flow address 7003 LT address 7002 Previous volume address 7007 SP address 7001 Totalflow base group number 0 FCU Scan Response timeout 29 Scan interval 3 Table 7.14: iCConnect FCU Tab - ROC 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
Page 1 and 2:
Operator’s Manual Revision: 4 Rev
Page 3 and 4:
ACiC Operator’s Manual Revision 4
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24: ACiC Operator’s Manual Revision 4
Page 73: 1. 2. 3. 4. 5. 6. 7. 8. 9. ACiC Ope
Page 77 and 78: 1. 2. 3. 4. 5. 6. ACiC Operator’s
Page 85 and 86: 1. 2. 3. 4. 5. 6. 7. ACiC Operator
Page 95: 8. 9. ACiC Operator’s Manual Revi
show all

Operator's Manual – AutoCycle iC - Ferguson Beauregard

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?