Operator's Manual – AutoCycle iC - Ferguson Beauregard

1.
2.
3.
4.
5.
6.
7.
ACiC Operator’s Manual Revision 4 Page 94 of 95
From the Tools menu, choose Enable/Disable
Functions.
Choose Enabled for one of the four unused
Scanner Functions.
Press Apply and press the OK button.
From the System Configurations tree, select RTU
Port Configuration.
Choose Comm 4 or Comm 5 and select 9600 Baud,
8 Data Bits, No Parity, and 1 Stop Bit for the
communications properties of that port (Comm 4
depicted).
Set the Scanner Port # to the previously chosen
Comm #.
Push the Apply button.
Figure 8.5: AutoPILOT: Communication Port Configuration
Figure 8.4: AutoPILOT Functions Configuration
2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567