Operator's Manual – AutoCycle iC - Ferguson Beauregard

Recommendations

Info

ACiC Operator’s Manual Revision 4 Page 36 of 95 93 MAX CP SHUT IN: Maximum Casing Pressure is the high limit, that when reached, will put controller into Manual Mode and close the valve. 94 MIN TP SHUT IN: Minimum Tubing Pressure is the low limit, that when reached, will put controller into Manual Mode and close the valve. 95 MAX TP SHUT IN: Maximum Tubing Pressure is the high limit, that when reached, will put controller into Manual Mode and close the valve. HI DP WAIT >=: This set point is used with the LL3 Recovery option. If DP is greater than or equal to this set point, the RTU assumes another well is producing into the production facility and will not open the sales valve. Once DP is less than this set point, it must remain below the set point for HI DP DELAY time before the RTU will open the sales valve. CLS RM DP =: Close the Tubing Valve if the Remote Line Pressure is greater-than or equal-to the PSIG setting. RM H-L DLY: High-Line Delay for the Remote LP sensor. CLS IF CP-TP decrease adjustment for Fast Arrival. OP SL TP-LP (+): Open if TP-LP > increase adjustment for Slow Arrival. OP NA TP-LP (+): Open if TP-LP > increase adjustment for No Arrival. OP FS FSLG (+): Open if FSLUG >= increase adjustment for Fast Arrival. OP SL FSLG (-): Open if FSLUG >= decrease adjustment for Slow Arrival. OP NA FSLG (-): Open if FSLUG >= decrease adjustment for No Arrival. OP F RLP (-): Open if Remote CP >= decrease adjustment for Fast Arrival. OP S RLP (+): Open if Remote CP >= increase adjustment for Slow Arrival. 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
ACiC Operator’s Manual Revision 4 Page 37 of 95 OP N RLP (+): Open if Remote CP >= increase adjustment for No Arrival. RM LP ENABLED: Enable Remote Line Pressure Sensor. RM DP ENABLED: Enable Remote Differential Pressure Sensor RM LP CLR ENA: Enable Remote High Line Pressure Clear feature RM LPC DLY: The delay before a High Line Pressure error using the remote Line Pressure is cleared. RM LP CLR
Page 1 and 2: Operator’s Manual Revision: 4 Rev
Page 3 and 4: ACiC Operator’s Manual Revision 4
Page 35: ACiC Operator’s Manual Revision 4
Page 73 and 74: 1. 2. 3. 4. 5. 6. 7. 8. 9. ACiC Ope
Page 77 and 78: 1. 2. 3. 4. 5. 6. ACiC Operator’s
Page 85 and 86: 1. 2. 3. 4. 5. 6. 7. ACiC Operator
Page 87 and 88:
ACiC Operator’s Manual Revision 4
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95:
8. 9. ACiC Operator’s Manual Revi
show all

Operator's Manual – AutoCycle iC - Ferguson Beauregard

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?