Operator's Manual – AutoCycle iC - Ferguson Beauregard

Recommendations

Info

1. 2. 3. ACiC Operator’s Manual Revision 4 Page 78 of 95 From the Configure menu, choose Modbus and then Registers. Enter the information in to Table 7.16 or Table 7.17. Be sure to choose the proper Turbine or Orifice Meter if there is more than one being controlled by the device. The ACiC can utilize only one flow measurement device. Assign the entered registers to the Comm port being used. Click Apply. Click Update. Starting Register Ending Register Point Type Parameter Indexing Conversion 7001 7001 115 16 Parameter 0 7002 7002 115 18 Parameter 0 7003 7003 116 0 Parameter 0 7004 7005 116 12 Parameter 0 Table 7.16: ROC 800 Turbine Meter Configuration Starting Register Ending Register Point Type Parameter Indexing Conversion 7000 7000 113 26 Parameter 0 7001 7001 113 28 Parameter 0 7002 7002 113 30 Parameter 0 7003 7003 114 0 Parameter 0 7004 7005 114 19 Parameter 0 Table 7.17: ROC 800 Orifice Meter Configuration Figure 7.24: ROC Parameter Assignment Figure 7.25: ROC Modbus Register Assignment 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
ACiC Operator’s Manual Revision 4 Page 79 of 95 7.4 ABB Totalflow To configure the TotalFlow® unit you will need the PCCU32 application provided by The ABB Group at http://www.abb.com/totalflow. Included in the section are examples for configuring the following flow computers: Totalflow μFlo 6213 Totalflow XFC 6410 Totalflow XFC G4 6410 2913 Specialty Drive • P.O. Box 130158 • Tyler, TX 75713-0158 • Phone: 903-561-4851 • Fax: 903-561-6567
Page 1 and 2:
Operator’s Manual Revision: 4 Rev
Page 3 and 4:
ACiC Operator’s Manual Revision 4
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28: ACiC Operator’s Manual Revision 4
Page 73 and 74: 1. 2. 3. 4. 5. 6. 7. 8. 9. ACiC Ope
Page 77: 1. 2. 3. 4. 5. 6. ACiC Operator’s
Page 85 and 86: 1. 2. 3. 4. 5. 6. 7. ACiC Operator
Page 95: 8. 9. ACiC Operator’s Manual Revi
show all

Operator's Manual – AutoCycle iC - Ferguson Beauregard

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?