User's Manual TNC 360 (from 259 900-11) - heidenhain

8 Cycles
8.2 Simple Fixed Cycles
TNC 360
Example: Slot milling
A horizontal slot 50 mm x 10 mm and a vertical
slot 80 mm x 10 mm are to be milled.
The starting position takes into account the tool
radius in the longitudinal direction of the slot.
Starting position slot 1 :
X = 76 mm Y = 15 mm
Starting position 2 :
X = 20 mm Y = 14 mm
SLOT DEPTHS: 15 mm
Setup clearances: 2 mm
Milling depths: 15 mm
Pecking depths: 5 mm
Feed rate for pecking: 80 mm/min
1 2
Slot length 50 mm 80 mm
1st milling direction – +
Slot widths: 10 mm
Feed rate: 120 mm/min
SLOT MILLING cycle in a part program
100
90
10
Y
2
10
10
X
15 30 80 100
0 BEGIN PGM 360811 MM
1 BLK FORM 0.1 Z X+0 Y+0 Z–20
2 BLK FORM 0.2 X+100 Y+100 Z+0
3 TOOL DEF 1 L+0 R+4
4 TOOL CALL 1 Z S1000
5 CYCL DEF 3.0 SLOT MILLING ........................... Slot parallel to X-axis
6 CYCL DEF 3.1 SET UP –2 ................................... Setup clearance
7 CYCL DEF 3.2 DEPTH –15 ................................. Milling depth
8 CYCL DEF 3.3 PECKG –5 F80 ............................ Pecking depth, feed rate for pecking
9 CYCL DEF 3.4 X–50 ............................................ Slot length and first milling direction (–)
10 CYCL DEF 3.5 Y+10 ........................................... Slot width
11 CYCL DEF 3.6 F120 ............................................ Feed rate
12 L Z+100 R0 FMAX M6
13 L X+76 Y+15 FMAX M3 ..................................... Approach starting position, spindle on
14 L Z+2 F1000 M99 ............................................... Pre-positioning in Z, cycle call
15 CYCL DEF 3.0 SLOT MILLING ........................... Slot parallel to Y-axis
16 CYCL DEF 3.1 SET UP –2 ................................... Setup clearance
17 CYCL DEF 3.2 DEPTH –15 ................................. Milling depth
18 CYCL DEF 3.3 PECKG –5 F80 ............................ Pecking depth, feed rate for pecking
19 CYCL DEF 3.4 Y+80 ........................................... Slot length and first milling direction (+)
20 CYCL DEF 3.5 X+10 ........................................... Slot width
21 CYCL DEF 3.6 F110 ............................................ Feed rate
22 L X+20 Y+14 FMAX ........................................... Approach starting position
23 CYCL CALL ......................................................... Cycle call
24 L Z+100 FMAX M2
25 END PGM 360811 MM
1
8-11