User's Manual TNC 360 (from 259 900-11) - heidenhain

3 Test Run and Program Run
3.2 Program Run
In the PROGRAM RUN / FULL SEQUENCE mode of operation the TNC
executes a part program continuously to its end or up to a program stop.
In the PROGRAM RUN /SINGLE BLOCK mode of operation you execute
each block separately by pressing the machine START button.
The following TNC functions can be used during a program run:
• Interrupt program run
• Start program run from a certain block
• Blockwise transfer of very long programs from external storage
• Checking/changing Q parameters
• Graphic simulation of a program run
To run a part program:
• Clamp the workpiece to the machine table.
• Set the datum
• Select the program.
PROGRAM RUN / SINGLE BLOCK
or
PROGRAM RUN / FULL SEQUENCE
Select the part program.
GOTO
0 ENT
I
Only in mode
PROGRAM RUN /
SINGLE BLOCK
I
repeatedly
Go to the first block of the program.
Run the part program.
Run each block of the part program separately.
The feed rate and spindle speed can be changed with the override knobs.
TNC 360 3-3