Linkage Kit Manual V6-00 - Fujitsu

CHAPTER 6 LINKER OPTIONS
6.2.10 Map List File Name Specification (-m)
This option specifies the name of the map list file to be output by the linker.
If this option is not specified, a file name is created from the output load module file
name.
■ Map List File Name Specification (-m)
[Format]
-m < Map list file name > ( Default )
[Parameters]
Output map list file name
The parameters cannot be omitted.
[Description]
By default, the linker outputs a map list file. At this point, a file is created with the name of the output
load module file whose extension is changed to ".mp1".
The -m option is used to change the default map list file name.
If the -m option is specified after the -Xm option, the -Xm option can be canceled.
[Example]
flnk911s a1 a2 a3 -r -o a123.rel -m a123.map
The map list file name output by the linker is changed to a123.map.
106 PART II LINKER