Linkage Kit Manual V6-00 - Fujitsu

CHAPTER 2 OPTIONS
2.1 Option
An option consists of an option name and parameter. This section gives a synopsis of
an option and how to specify an option.
■ Synopsis of Option
The following section is a synopsis of an option.
-Optionname [Parameter] ...
Add a hyphen (-) to the top of the option name.
Insert a space to separate the option name from the parameter.
Whether the parameter is used or not used and the format of the parameter is defined in each option. Refer
to the description of the respective options.
Pay attention to the following points when specifying an option.
• Capital letters and small letters of alphabetical letters must be distinguished when specifying option
name.
• When a parameter needs an option, the parameters cannot be omitted entirely.
• When specifying two or more options, they cannot be specified as a group. For example, -a and -V as
-aV is not acceptable.
• Spaces cannot be used in between hyphens and the option name.
■ Parameter
Parameters are used to specify a file name or module name, which become the target of operation of an
option. Two or more parameters are usually separated using a comma (,). However, symbols other than
the comma (,) are also used when specifying sophisticated parameters. Refer to the description of each
option for more details.
[Example]
-a
gets.obj,puts.obj,getc.obj,putc.obj
-sc CODE=0xC1000,DATA=0x1000
22 PART I LINKAGE KIT