Linkage Kit Manual V6-00 - Fujitsu

15.3 Details of Load Module Converter Options
15.3.1 Specifying to Output S Format (-S1/-S2/-S3)
This option specifies the format used to output data.
■ Specifying to Output S Format (-S1/-S2/-S3)
[Format]
-S1
-S2
-S3
[Parameter]
None
[Description]
Specifies the format used to output data.
f2ms outputs the data using either the S1 record, S2 record or the S3 record.
It will not output if both the S1 record and the S2 record are used.
The -S1, -S2 and -S3 options take effect when specified last. If these options are not specified, the f2ms
command outputs data in mixed formats of S1/S2/S3 according to the data address.
Note:
If the specification with this option conflicts with the output range, this option outputs an error and
performs no processing.
The terminator record (S9 record, S8 record, S7 record) for output varies with the specification of this
option. (See Table 15.3-1)
Table 15.3-1 Output S Format Specification List
Specification Range of data that can be output Terminator record Remarks
-S1 0x00000000-0x0000FFFF S9 record 16-bit address
-S2 0x00000000-0x00FFFFFF S8 record 24-bit address
-S3 0x00000000-0xFFFFFFFF S7 record 32-bit address
PART IV OBJECT FORMAT CONVERTERS 269