Linkage Kit Manual V6-00 - Fujitsu

APPENDIX
B.1 Common Format
The HEX format consists of six fields, (a) to (f).
Each field is set using the ASCII code. Field (g) is explained later.
■ Common Format
Figure B-1 Common Format
: I1 I2 a1a2a3a4t1 t2 d1d2d3d4 d* d* d* d* s1s2
(a) (b) (c) (d) (e) (f) (g)
(a):
Indicates the start of a record. The character ":" (0x3A) is used.
(b):
Indicates the number of bytes in the data part of (e).
Since the actual 1-byte data is represented by 2-byte ASCII code in this format, d1 and d2 in the above
figure are counted as one.
I1 indicates the high-order digits and I2 indicates the low-order digits. Values in the range of 0 to 255
can be set.
It is "00" to "FF" in ASCII notation and "0x3030" to "0x4646" in hexadecimal notation.
(c):
Indicates the address allocated to the first data if the contents of (e) are object data.
a1 indicates the high-order digits and a4 indicates the low-order digits. Values in the range of 0 to 65535
can be set.
It is "0000" to "FFFF" in ASCII notation and "0x30303030" to "0x46464646" in hexadecimal notation.
(d):
Indicates the record type.
00: Data record (HEX8/HEX16/HEX32 format)
01: End record (HEX8/HEX16/HEX32 format)
02: Extended segment address record (HEX16/HEX32 format)
03: Start segment address record (HEX16/HEX32 format)
04: Extended linear address record (HEX32 format)
05: Start linear address record (HEX32 format)
(e):
This field depends on the record type of (d). See the explanations of each record in Appendix "B.2 Data
Record (HEX8/HEX16/HEX32) Type: 00" to Appendix "B.7 Start Linear Address Record (HEX32)
Type: 05".
346