Linkage Kit Manual V6-00 - Fujitsu

3.2 Details of Common Options
3.2.9 Specifying to Set the End Code to 0 When Warning is
Issued (-Xcwno)
It sets the end code to 0 when a warning is issued while the program is being executed.
■ Specifying to Set the End Code to 0 When Warning is Issued (-Xcwno)
[Format]
-Xcwno
[Parameter]
None
[Description]
It returns the end code to 0, that is the default value, when warning only is issued during execution of
program.
SOFTUNE linkage kit sets the end code to 0 when warning only is issued.
Use this option to cancel the option (-cwno) that sets the end code to 1 when warning is issued.
[Example 1]
flnk911s ccp903
flnk911s ccp903 -Xcwno
When warning only is issued during execution of program, the end code is 0 in the default setting.
The two settings as specified above are the same.
[Example 2]
f2ms -f lkit.opt ccp903 -Xcwno
When a program is executed using option files, setting of an option file may occasionally need temporary
changes.
When the -cwno option is used in lkit.opt, the -cwno option can be canceled by specifying -Xcwno on the
command line without changing contents of the lkit.opt.
PART I LINKAGE KIT 39